22-05-2018, 03:17 PM
In my case, I have an SU carb on my RN and the butterfly would not open fully when adjusted to be fully closed, and vice versa. The throw of the throttle linkage was not enough to complete the full arc required.
I could get it to idle nicely but it was not too keen on hills or the traffic light grand prix!
My solution was to weld about 3/4" into the short part of the pedal below the footpad, thus increasing the pedal movement. Problem resolved immediately!
I could get it to idle nicely but it was not too keen on hills or the traffic light grand prix!
My solution was to weld about 3/4" into the short part of the pedal below the footpad, thus increasing the pedal movement. Problem resolved immediately!