31/32 rear axle oil seal

[Howard Wright]

Hi All

I have a 31/32 rear axle where the torque tube to banjo joint includes shims to get the CW&P mesh correct.

There is no mention in Woodrow about how to seal this joint.  I put it together with just the shims and no gasket goo, however I’m now getting a very small oil leak from the joint.

What do others use to seal this joint?  I’m a little concerned that any sealant may throw the mesh out.

Cheers

Howard

[AustinWood]

I doubt that it's a problem. Perhaps slightly less oil in the axle would prevent it. The specified quantity is over-generous.

[Bob Culver]

It stops the diff housing rusting. Can smear Si around the assembled joint.