21-05-2021, 09:50 PM
Hi Colin,
I Would use 262 Studlock
Any of the thread lockers can be removed by applying Heat about 230 Degrees C
so no need to worry about them being permanent
One other thing looking at the photo i would have a light Skim taken of the top of crankcase
(PS) also a small counter sink to the stud hole so that it does not pull up when fitted
Hope that is of some help
Colin
NZ
I Would use 262 Studlock
Any of the thread lockers can be removed by applying Heat about 230 Degrees C
so no need to worry about them being permanent
One other thing looking at the photo i would have a light Skim taken of the top of crankcase
(PS) also a small counter sink to the stud hole so that it does not pull up when fitted
Hope that is of some help
Colin
NZ