08-03-2021, 11:50 PM
Ramp at full lift,1.2mtrs.I have made some cross beams which slot across the channels to lift the axles (As MOT ramps) using scissor jacks to work on the car at a better height than the floor.
I had the channels folded in 3mm but would now have them folded in 4mm as they weren't stiff enough and reinforced them with the industrial racking bars (Free)
It would be possible to remove /unbolt the folded channels and fit the reach arms but would be a bit of a faff to do.
I don't have the space for a 2 or 4 poster,For a Seven this takes up virtually no more space.
For any ramp you will need a high roof,Although by hooking up with the hydraulic pump it is possible to wheel it outside if you have a concrete base or similar.
A friend of mine has a saying,"You won't get a mower that does everything" Same goes for ramps,Lathes and milling machines
I had the channels folded in 3mm but would now have them folded in 4mm as they weren't stiff enough and reinforced them with the industrial racking bars (Free)
It would be possible to remove /unbolt the folded channels and fit the reach arms but would be a bit of a faff to do.
I don't have the space for a 2 or 4 poster,For a Seven this takes up virtually no more space.
For any ramp you will need a high roof,Although by hooking up with the hydraulic pump it is possible to wheel it outside if you have a concrete base or similar.
A friend of mine has a saying,"You won't get a mower that does everything" Same goes for ramps,Lathes and milling machines