16-10-2019, 07:04 PM
(This post was last modified: 16-10-2019, 07:05 PM by Ian McGowan.)
Pete, once you have fitted/ fabricated a suitable funnel my way is: fill the little funnel with preferred oil (in my case EP90) then as invariably the little hole into the ball-race is clogged up, "rod" the funnel, feeling carefully for the little exit hole with a short length of 1.25mm stiff wire. Once you have found the hole and dislodged the crud, the oil in the funnel will fairly quickly drain down into the bearing. Endex.