26-09-2019, 11:39 AM
(This post was last modified: 26-09-2019, 11:40 AM by Bob Culver.)
Hand scraping large adjustements can easily result in a tilted rod. When this topic arose previously one contributor with a large swing lathe did by clamping half way on a wood or nylon (or steel covered with paper) mandrel in chuck, then reversing, and finishing with a scraper! The fun of lathe work is the challenge of set ups.
With scraping it is very easy to start chatter marks, hard to remove.
With scraping it is very easy to start chatter marks, hard to remove.