03-04-2019, 09:19 AM
There are I think 3 basic possibilities:
1 bearing outer races have end play in the casing joint.
2 shaft has end play in the inner races
3 the bearings themselves have internal slack allowing the shaft to move even though the outers are firmly clamped in hsg and inners are tight on the shaft. This might be because they are installed the wrong way round.
1 bearing outer races have end play in the casing joint.
2 shaft has end play in the inner races
3 the bearings themselves have internal slack allowing the shaft to move even though the outers are firmly clamped in hsg and inners are tight on the shaft. This might be because they are installed the wrong way round.