05-03-2019, 11:33 PM
Now you mention it I'm not so sure! However I'm a bit puzzled. Looking on A7Components catalogue only pairs are listed, not differentiated between front and back. So you must be right.
All four levers should be approximately vertical when the brakes are applied. To achieve this the front cams are probably set at a different angle side to side to bring them slightly forward of vertical at rest.
However the front cams are directly below the king pin while the rears are at an angle of about 45 degrees.
I would have thought that the front cams are at an angle close to 90 degrees and the rears close to 45 degrees.
I'm house sitting for a friend at the moment otherwise I'd go and have a look at it.
I seem to be confusing the issue!!
All four levers should be approximately vertical when the brakes are applied. To achieve this the front cams are probably set at a different angle side to side to bring them slightly forward of vertical at rest.
However the front cams are directly below the king pin while the rears are at an angle of about 45 degrees.
I would have thought that the front cams are at an angle close to 90 degrees and the rears close to 45 degrees.
I'm house sitting for a friend at the moment otherwise I'd go and have a look at it.
I seem to be confusing the issue!!
Jim