The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Girling Backplate Bolts

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Girling Backplate Bolts
Matt_Harnden Offline
Member
***
Joined: Aug 2017 Posts: 56 Threads: 24
Reputation: 1
#1
20-01-2019, 05:22 PM
Please can someone confirm the correct bolt type (thread and length) to secure a Girling backplate to the rear axle Huh .

(I think I have worked it out but would like a second opinion!)

Many thanks.
Reply
Ruairidh Dunford Offline
Bearded Wizard
*******
Joined: Mar 2015 Posts: 5,195 Threads: 223
Reputation: 59
Location: Scotchland
#2
20-01-2019, 05:41 PM (This post was last modified: 20-01-2019, 05:42 PM by Ruairidh Dunford.)
I think they are 5/16 BSF by 1/2" - I also think that the one nearest the cotter pin benefits from being slightly shorter again.
https://gordonenglandregister.wordpress.com/
Reply
Ian Dunford Offline
Member
***
Joined: Aug 2017 Posts: 209 Threads: 1
Reputation: 7
#3
20-01-2019, 05:42 PM
5/16ths BSF by 1/2 an inch
Reply
Matt_Harnden Offline
Member
***
Joined: Aug 2017 Posts: 56 Threads: 24
Reputation: 1
#4
20-01-2019, 05:58 PM
(20-01-2019, 05:41 PM)Ruairidh Dunford Wrote: I think they are 5/16 BSF by 1/2" - I also think that the one nearest the cotter pin benefits from being slightly shorter again.

Thanks Ruairdh. I had guessed the same thread but 5/8" long. Good advice about the cotter pin - this was my reason for removing the backplate bolts...and hub. Made life a lot easier (if more work).

Cheers.

Matt
Reply
Ruairidh Dunford Offline
Bearded Wizard
*******
Joined: Mar 2015 Posts: 5,195 Threads: 223
Reputation: 59
Location: Scotchland
#5
20-01-2019, 06:07 PM
5/8" could well be correct - let me know when you find out for sure.
https://gordonenglandregister.wordpress.com/
Reply
Steve Jones Offline
Pass the hammer
*****
Joined: Aug 2017 Posts: 1,397 Threads: 25
Reputation: 16
Location: North Yorkshire
#6
20-01-2019, 08:12 PM
I made a set of these recently. 5/16 BSF by 5/8" but it helps to reduce the length of the one by the cotter. In the end, it's not critical. Any thread that pokes out of the bosses in the axle ends does nothing.

Steve
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)