| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
|
|
1st motion shaft
|
12-12-2018, 12:06 AM
The circlip on the large first motion shaft bearing is there to act as a flange to position it in a recess in the casing. It does not need to be removed EXCEPT that replacement bearings often have a circlip which is fractionally too large to fit in the recess. I found out the hard way and had to take the replacement bearing out again in order to swap the circlip.
Peter. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
1st motion shaft - by Simon Scott - 11-12-2018, 05:50 PM
RE: 1st motion shaft - by Chris KC - 11-12-2018, 06:13 PM
RE: 1st motion shaft - by Terrytuned - 11-12-2018, 06:16 PM
RE: 1st motion shaft - by Simon Scott - 11-12-2018, 06:23 PM
RE: 1st motion shaft - by Dave Mann - 11-12-2018, 06:49 PM
RE: 1st motion shaft - by Chris KC - 11-12-2018, 06:59 PM
RE: 1st motion shaft - by jansens - 11-12-2018, 07:59 PM
RE: 1st motion shaft - by Chris KC - 11-12-2018, 08:01 PM
RE: 1st motion shaft - by jansens - 11-12-2018, 08:15 PM
RE: 1st motion shaft - by Simon Scott - 11-12-2018, 08:57 PM
RE: 1st motion shaft - by Peter Naulls - 12-12-2018, 12:06 AM
RE: 1st motion shaft - by Dave Mann - 12-12-2018, 06:12 PM
RE: 1st motion shaft - by Chris KC - 12-12-2018, 06:27 PM
RE: 1st motion shaft - by Reckless Rat - 12-12-2018, 06:41 PM
RE: 1st motion shaft - by Simon Scott - 13-12-2018, 02:36 PM
RE: 1st motion shaft - by Chris KC - 13-12-2018, 04:43 PM
|
