| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
|
|
1st motion shaft
|
11-12-2018, 08:57 PM
I have already been told what will happen if I put it in the oven?? so need to try an alternative. With bit of luck new springs and balls and sorting the end float is all that will be required. I’ve only been 7ing a couple of years and totally in awe of the “just fixed it roadside and carried on” skills.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
1st motion shaft - by Simon Scott - 11-12-2018, 05:50 PM
RE: 1st motion shaft - by Chris KC - 11-12-2018, 06:13 PM
RE: 1st motion shaft - by Terrytuned - 11-12-2018, 06:16 PM
RE: 1st motion shaft - by Simon Scott - 11-12-2018, 06:23 PM
RE: 1st motion shaft - by Dave Mann - 11-12-2018, 06:49 PM
RE: 1st motion shaft - by Chris KC - 11-12-2018, 06:59 PM
RE: 1st motion shaft - by jansens - 11-12-2018, 07:59 PM
RE: 1st motion shaft - by Chris KC - 11-12-2018, 08:01 PM
RE: 1st motion shaft - by jansens - 11-12-2018, 08:15 PM
RE: 1st motion shaft - by Simon Scott - 11-12-2018, 08:57 PM
RE: 1st motion shaft - by Peter Naulls - 12-12-2018, 12:06 AM
RE: 1st motion shaft - by Dave Mann - 12-12-2018, 06:12 PM
RE: 1st motion shaft - by Chris KC - 12-12-2018, 06:27 PM
RE: 1st motion shaft - by Reckless Rat - 12-12-2018, 06:41 PM
RE: 1st motion shaft - by Simon Scott - 13-12-2018, 02:36 PM
RE: 1st motion shaft - by Chris KC - 13-12-2018, 04:43 PM
|
