31-08-2017, 05:54 AM
(This post was last modified: 31-08-2017, 06:00 AM by Ian Williams.
Edit Reason: Add info
)
Here is a finished Nippy seat and a close up of the Hidem banding and piping round the edge, as stated earlier there should be a D shaped moulding instead of the Hidem and I may change that later.
DSC06245.JPG (Size: 149.31 KB / Downloads: 474)
DSC06247.JPG (Size: 153.93 KB / Downloads: 473)
DSC06248.JPG (Size: 155.66 KB / Downloads: 473)
DSC06243.JPG (Size: 130.74 KB / Downloads: 473)
And PS the wood was ash, the top part made up from laminated strips, the side pieces were steamed and clamped over a former. the bottom part is 3/16" three ply, steamed and fitted directly to the seat base with brass brake rivets. The metal frames were repaired and painted, I had to remake sections but did not think to photograph as I went along.
DSC06245.JPG (Size: 149.31 KB / Downloads: 474)
DSC06247.JPG (Size: 153.93 KB / Downloads: 473)
DSC06248.JPG (Size: 155.66 KB / Downloads: 473)
DSC06243.JPG (Size: 130.74 KB / Downloads: 473)
And PS the wood was ash, the top part made up from laminated strips, the side pieces were steamed and clamped over a former. the bottom part is 3/16" three ply, steamed and fitted directly to the seat base with brass brake rivets. The metal frames were repaired and painted, I had to remake sections but did not think to photograph as I went along.
Black Art Enthusiast