19-05-2018, 08:48 PM
That looks about right.
I guess you are not getting the carb butterfly fully open, so thinking the pedal is too short.
If all the parts are standard, there should be enough movement to work the carb.
I had this problem, it was caused by the hand throttle lever slipping round the control tube and the linkage then stopped the accelerator pedal moving through the correct arc.
Simon
I guess you are not getting the carb butterfly fully open, so thinking the pedal is too short.
If all the parts are standard, there should be enough movement to work the carb.
I had this problem, it was caused by the hand throttle lever slipping round the control tube and the linkage then stopped the accelerator pedal moving through the correct arc.
Simon