What do people make up or use for a missing little metal oiler cap which sits above the shaft for the brass bush that holds the O/S end of the dynamo spindle?
And does that bush below need to have a small hole drilled or not? I'm unsure if some of the units I've looked at have had bushes replaced and they are in oilite or something, which doesnt require lube, or doesnt require a hole?! Or if they have just not been drilled as they should be.
Any thoughts?
And does that bush below need to have a small hole drilled or not? I'm unsure if some of the units I've looked at have had bushes replaced and they are in oilite or something, which doesnt require lube, or doesnt require a hole?! Or if they have just not been drilled as they should be.
Any thoughts?