24-11-2021, 12:14 AM
After spending a lot of time trying to get my original Dynamo to charge and possibly failing.
I purchased another unit and last night managed to get it working.
The one on the car is still not showing any charge but I can install the replacement unit.
The replacement unit has end float of about 1/16” I guess
Is it necessary to reduce this before fitting??
I am reluctant to strip the working unit and wonder whether I could insert a packing washer near the large drive spiral??
Regards
Tim
I purchased another unit and last night managed to get it working.
The one on the car is still not showing any charge but I can install the replacement unit.
The replacement unit has end float of about 1/16” I guess
Is it necessary to reduce this before fitting??
I am reluctant to strip the working unit and wonder whether I could insert a packing washer near the large drive spiral??
Regards
Tim