07-05-2021, 09:08 AM
(This post was last modified: 07-05-2021, 09:34 AM by Martin Prior.)
We've used them on RN, RP, both Ruby models and Big Sevens.
I have original and new locking bolts in stock, plus original RN and RP sliding panels. I'll go and do some trial fitting.
I've now checked a recently-supplied repro knobset, which I believe all come from the same source, against an original RN mounting plate and repro plates (intended to fit all models) from two different suppliers. One of these plates came with the knobset in question.
The two closely-spaced holes in the front edge of the chromed face plate seem to be correct, but in all cases the single rear hole appears to be about 1/16" south-west of where it should be. It's close enough to work either with some slight easing of the holes, or alternatively with some brutal screwing, but either way, it's definitely not quite right.
I shall mention this to the supplier.
I have original and new locking bolts in stock, plus original RN and RP sliding panels. I'll go and do some trial fitting.
I've now checked a recently-supplied repro knobset, which I believe all come from the same source, against an original RN mounting plate and repro plates (intended to fit all models) from two different suppliers. One of these plates came with the knobset in question.
The two closely-spaced holes in the front edge of the chromed face plate seem to be correct, but in all cases the single rear hole appears to be about 1/16" south-west of where it should be. It's close enough to work either with some slight easing of the holes, or alternatively with some brutal screwing, but either way, it's definitely not quite right.
I shall mention this to the supplier.