The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DEL 1929 dynamo
#2
Jon, I don't know whether the CAV DEL in either long or short armature form has any significant advantages over the later C35A/M, other than being a nicer engineering answer due to the better bearings. The CAV is a four pole machine, the Lucas is a two pole but I can't see any practical advantages there.
Most of the internal resistances on CAV DEL dynamos are open circuit; I usually wire an external  7.5 or 10 ohm wire wound ceramic resistor between F and D to give 1/2 charge.

I've got a DEL short armature on my '29 RK saloon and it works very well at 7.5A/3A charge rate and has done for a few years now.
Reply


Messages In This Thread
DEL 1929 dynamo - by JonE - 15-07-2020, 10:56 AM
RE: DEL 1929 dynamo - by Parazine - 15-07-2020, 11:35 AM
RE: DEL 1929 dynamo - by JonE - 15-07-2020, 11:46 AM
RE: DEL 1929 dynamo - by Bob Culver - 15-07-2020, 09:05 PM
RE: DEL 1929 dynamo - by JonE - 16-07-2020, 09:20 AM
RE: DEL 1929 dynamo - by Parazine - 19-07-2020, 02:10 PM
RE: DEL 1929 dynamo - by JonE - 06-04-2021, 07:53 AM
RE: DEL 1929 dynamo - by AustinWood - 06-04-2021, 09:03 AM
RE: DEL 1929 dynamo - by Parazine - 06-04-2021, 10:09 AM
RE: DEL 1929 dynamo - by JonE - 06-04-2021, 10:19 AM
RE: DEL 1929 dynamo - by Parazine - 06-04-2021, 10:41 AM
RE: DEL 1929 dynamo - by Bob Culver - 06-04-2021, 08:42 PM
RE: DEL 1929 dynamo - by JonE - 07-04-2021, 03:40 PM
RE: DEL 1929 dynamo - by JonE - 09-04-2021, 06:41 PM
RE: DEL 1929 dynamo - by JonE - 16-07-2022, 08:14 PM
RE: DEL 1929 dynamo - by Lowespeed - 17-07-2022, 12:17 PM
RE: DEL 1929 dynamo - by Howard Wright - 17-07-2022, 12:24 PM
RE: DEL 1929 dynamo - by JonE - 17-07-2022, 12:25 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)