10-02-2020, 09:43 AM
Hi All
Engine building on the special has started and I have all the (standard) valves and springs in the block.
My friend is encouraging me to chamfer the top of the cylinder bores to aid gas flow. Bearing in mind I’m trying to build a “strong” engine not a race engine do the engine builders out there normally chamfer? If so by how much and to what profile?
Cheers
Howard
Engine building on the special has started and I have all the (standard) valves and springs in the block.
My friend is encouraging me to chamfer the top of the cylinder bores to aid gas flow. Bearing in mind I’m trying to build a “strong” engine not a race engine do the engine builders out there normally chamfer? If so by how much and to what profile?
Cheers
Howard