| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
|
|
Nippy head gasket
|
05-03-2019, 08:39 AM
Did this for an overbored block with aluminium head. The nip is made by the s/steel 'ring' which seems to work well. Some initial water escape from the manifold side which seems to have subsided. Head torqued to 20 lb ft only still using 5/16ths studs. No heat treatment.
Paul N-M |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Nippy head gasket - by Scarlet O'Hara - 28-02-2019, 02:15 PM
RE: Nippy head gasket - by Chris KC - 28-02-2019, 03:21 PM
RE: Nippy head gasket - by dickie65 - 28-02-2019, 11:50 PM
RE: Nippy head gasket - by Ruairidh Dunford - 01-03-2019, 12:18 AM
RE: Nippy head gasket - by Scarlet O'Hara - 01-03-2019, 12:01 PM
RE: Nippy head gasket - by John Mason - 01-03-2019, 02:34 PM
RE: Nippy head gasket - by Timothy P - 01-03-2019, 02:42 PM
RE: Nippy head gasket - by Chris KC - 01-03-2019, 06:05 PM
RE: Nippy head gasket - by dickie65 - 04-03-2019, 09:35 PM
RE: Nippy head gasket - by Phil Kingdom - 04-03-2019, 10:46 PM
RE: Nippy head gasket - by Paul N-M - 05-03-2019, 08:39 AM
RE: Nippy head gasket - by Zetomagneto - 05-03-2019, 10:16 AM
RE: Nippy head gasket - by Scarlet O'Hara - 05-03-2019, 11:05 AM
RE: Nippy head gasket - by Chris KC - 05-03-2019, 11:33 AM
RE: Nippy head gasket - by Colin Reed - 05-03-2019, 08:19 PM
RE: Nippy head gasket - by Bruce Nicholls - 05-03-2019, 09:51 PM
RE: Nippy head gasket - by Paul N-M - 07-03-2019, 05:11 PM
RE: Nippy head gasket - by Colin Reed - 07-03-2019, 07:48 PM
RE: Nippy head gasket - by Bob Culver - 07-03-2019, 08:36 PM
|
