30-08-2018, 08:43 PM
Having struggled to get my clutch right, and succeeded, I thought I would pass on one or two things I have learned the hard way.
If the slots in your cover plate are worn where the toggle bears against it is worth restoring with 1/4 bsf grub screws, flush with bottom of slot — ie as per original. If this is done and new pattern toggle levers used you will have a good clutch.
I suggest you don’t use the little rods under new toggle levers as it sets the levers far too high. I suspect that those who use the rods to good effect are making the best of old toggle levers.
The new pattern toggles are good I reckon but the fulcrum pins will not fit. I used an 8mm drill to run through. This is not kind on the drill bit as the toggles are case hardened but it works.
( note, my new levers came from Jamie and I don’t know if other cherished suppliers have ones with a different profile )
I hope this may be useful and save some midnight oil somewhere.
Charles
If the slots in your cover plate are worn where the toggle bears against it is worth restoring with 1/4 bsf grub screws, flush with bottom of slot — ie as per original. If this is done and new pattern toggle levers used you will have a good clutch.
I suggest you don’t use the little rods under new toggle levers as it sets the levers far too high. I suspect that those who use the rods to good effect are making the best of old toggle levers.
The new pattern toggles are good I reckon but the fulcrum pins will not fit. I used an 8mm drill to run through. This is not kind on the drill bit as the toggles are case hardened but it works.
( note, my new levers came from Jamie and I don’t know if other cherished suppliers have ones with a different profile )
I hope this may be useful and save some midnight oil somewhere.
Charles