27-04-2018, 12:54 PM
(27-04-2018, 09:59 AM)john williams Wrote: The fuel pump pressure is controlled by the diaphragm return spring. Pressure should be checked by disconnecting the outlet pipe, connect the pressure gauge to pump outlet, and motor the engine on the starter. Pressure should not exceed 1.5 lbsf/inch. Do not operate the priming lever to test pressure, as sometimes the priming lever will pull the diaphragm down further than the camshaft operating lever.
Thanks for that John Will try to check but not sure where I,will find a pressure gauge to do it.
To the previous reply, - there's no fuel in the float - it's OK.