|
Drive shaft
|
13-11-2021, 08:28 PM
What I could do is to take a section of yours with the spline and use a sleeve to fit to my shortened shaft. Shipping would cheaper too. My existing shaft is .88 inches in diameter. I have sent an email to Tony Betts to inquire if he may have one. I also sent an email to a USA firm that deals in drive shafts to see if they have anything in a 10 spline shaft 1 inch in diameter. I truly appreciate your interest in this matter. Arnie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Drive shaft - by SneezerUSA - 13-11-2021, 01:43 AM
RE: Drive shaft - by JonE - 13-11-2021, 03:41 PM
RE: Drive shaft - by SneezerUSA - 13-11-2021, 04:02 PM
RE: Drive shaft - by JonE - 13-11-2021, 07:52 PM
RE: Drive shaft - by SneezerUSA - 13-11-2021, 08:28 PM
RE: Drive shaft - by leaf200 - 15-11-2021, 12:34 PM
RE: Drive shaft - by SneezerUSA - 15-11-2021, 01:03 PM
RE: Drive shaft - by squeak - 15-11-2021, 10:53 PM
RE: Drive shaft - by Steve Jones - 16-11-2021, 01:17 PM
RE: Drive shaft - by SneezerUSA - 16-11-2021, 06:05 PM
RE: Drive shaft - by Steve Jones - 16-11-2021, 08:23 PM
|
