17-03-2021, 10:04 AM
If it’s any help Jon, I cleaned out a badly silted up block from a ‘36 two bearing motor some years @go using the old curtain spring in a drill trick, before I was aware of using chemicals.
There was no gap between the cylinders at all, I left it as it was assuming that was normal, put the engine together and used it London traffic for years, putting 60,000 on the motor without an issue.
That block was +40 at the time and I hate to admit it, was on Cords rings, again without issue!
There was no gap between the cylinders at all, I left it as it was assuming that was normal, put the engine together and used it London traffic for years, putting 60,000 on the motor without an issue.
That block was +40 at the time and I hate to admit it, was on Cords rings, again without issue!