05-01-2020, 07:42 PM
(This post was last modified: 05-01-2020, 07:47 PM by Bob Culver.)
My own lathe uses two cheap household switches (one of two way) and I soon learned to exercise caution with the sequence!
The DFK switch has terminals to both break the line wires and reverse the start winding and mid position with all disconnected.
The handwheel on end of leadscrew was the only hand end feed on some basic lathes. Is the main feed inconveniently rapid?
The DFK switch has terminals to both break the line wires and reverse the start winding and mid position with all disconnected.
The handwheel on end of leadscrew was the only hand end feed on some basic lathes. Is the main feed inconveniently rapid?