14-09-2019, 11:06 PM
(This post was last modified: 14-09-2019, 11:11 PM by Colin Reed.
Edit Reason: E xtra info
)
HI Tony,
Sounds like a great project and good Luck,
Just a couple of things.
your explanation re Forging or billet is spot on
cost wise the billet is the only way for small runs
Both types use Nitriding which will penetrate .010 to .015 th so if needing a regrind just re nitride
some form of counter weights I feel would be beneficial
Re Fly Wheel a much lighter mass on the OD would help if thinking of manufacturing
Coiln
NZ
Sounds like a great project and good Luck,
Just a couple of things.
your explanation re Forging or billet is spot on
cost wise the billet is the only way for small runs
Both types use Nitriding which will penetrate .010 to .015 th so if needing a regrind just re nitride
some form of counter weights I feel would be beneficial
Re Fly Wheel a much lighter mass on the OD would help if thinking of manufacturing
Coiln
NZ