22-07-2019, 08:48 PM
Now that I have done the sliding roof, the next job is the windscreen rubber, (see other posts re this) BUT after that is replacing the wing piping on the offside rear wing. Reading the companion page 61 paragraph 3 it states, and I quote, " The nuts are fixed into the wheel arch rivet style and must be carefully sawn and split in order to remove the bolts." Firstly does this mean that the bolts cannot be undone at all in order to slip the piping in unless the nuts are destroyed and what happens to replace the nuts? Can you just put nuts on as normal? If I have to saw the nuts what is the best way to go about this? What direction do you saw? I am asking as I don't want to go to all the trouble of taking out the seating and internal wheel arch covers if the job is a nightmare!