12-04-2019, 02:40 PM



Spent a couple of hours making nut cages to pop rivet on to the under sills. A nice, if fiddly job , but at least it was by the fireside in the comfort of the house!
Thinking I can now? Put in the prop shaft and also the gearbox ? Then the rear transmission tunnel?
Next stop : Engine in chassis next week?
First I need to get into behind the rear trim panels to make some sort of captive nut set up on each side , for just one per side rear wing attachment screws. Or I may just glue a block of ash and make that one a coach screw fitment.
Weekend off for grand parenting duties...
Regards
Bill G
Based near the Scottish Border,