13-03-2019, 06:12 PM
I learned to limbo this afternoon while working on the
Cup...
To fix all the parts for the handbrake I had to take out all
the floors but leaning in or squatting inside the chassis
was a real stretch. So crawled in under the chassis rail
and sat up to bolt up the twin ratchet , before I fitted
The prop shaft.
Finally decided to scrap my old downpipe as the route
under the “hoop” is not viable, however the old pipe
will help define the shape
of the new one. My pal Peter has a pipe bender so will
shortly be paying him a visit!
Regards
Bill G
Cup...
To fix all the parts for the handbrake I had to take out all
the floors but leaning in or squatting inside the chassis
was a real stretch. So crawled in under the chassis rail
and sat up to bolt up the twin ratchet , before I fitted
The prop shaft.
Finally decided to scrap my old downpipe as the route
under the “hoop” is not viable, however the old pipe
will help define the shape
of the new one. My pal Peter has a pipe bender so will
shortly be paying him a visit!
Regards
Bill G
Based near the Scottish Border,