12-03-2019, 04:23 PM
I am new to this forum and apologise if this question has been asked before. I am replacing the oil felts in the rear axle on my Mk 2 Ruby. I bought a pair of lip seals from the old Seven Workshop a while ago but I am finding it impossible to get them to go into the metal cups in the casing. I turned up a drift that fits the bore and is just smaller than the O.D. of the seal but to no avail. The new Seven Workshop are sending me some more as they have not heard of any problems with those they now sell.
I have owned my Seven since 1962 when I bought it from a scrap yard for £5 and then a little later I bought another for spares for £2 some of which I am still using for replacements, although I never got around to fitting the twin carb set up that I bought. I will be downsizing soon, is this the place to advertise my unwanted bits? Martyn
I have owned my Seven since 1962 when I bought it from a scrap yard for £5 and then a little later I bought another for spares for £2 some of which I am still using for replacements, although I never got around to fitting the twin carb set up that I bought. I will be downsizing soon, is this the place to advertise my unwanted bits? Martyn