09-03-2019, 02:30 PM
(This post was last modified: 09-03-2019, 02:34 PM by Peter Johnson.)
FWIW I could not get the downpipe to fit either side of the hoop. The new pattern downpipes are nothing like the original pipe on my New Zealand car. In the end, I cut the flange off at the manifold end and took an inch or so out. With a bit of bending, the pipe travels through the hoop. It is, however, very close to the carb so I have wrapped it in some insulation.
Peter
ETA. I haven’t used the chummy pattern silencer. I decided to use a stainless round silencer to similar dimensions, but without the mounting brackets.
Peter
ETA. I haven’t used the chummy pattern silencer. I decided to use a stainless round silencer to similar dimensions, but without the mounting brackets.