07-10-2017, 02:50 PM
(05-10-2017, 11:33 AM)Dan Cole Wrote:(03-10-2017, 09:52 AM)Timww0 Wrote: Hi all,
I have just bought a Chummy project with a very rotten floor pan, does any one have a drawing for the floor pan?
Tim
Hi Tim, I do not have drawings but I do have an original AD floorpan (currently separate from chassis and body) in original un-restored condition (currently awaiting attention!). It has surface corrosion and only some small local areas that need repair so it would be fine for checking dimensions or to use for producing a drawing. Not sure where you are based but I am in Bristol and if am happy to help if I can.
Good luck!
Dan
Hi Dan,
That would be brilliant if I could come and measure it. I did send you a private message, did you get it?
Regards
Tim