05-07-2018, 04:28 PM
Thanks... that does make sense...I did not appreciate that is still the case with a solid as opposed to split bush. My car had some of each!
I can get the king pins reamed "off car" into the hubs, but does that address the problem...unless I take the front axle off!
The bushes in the rear spring will certainly not be deformed as I throw them into the eye!, so I can do them off car. It was suggested that I coat them with solder to increase the o/d.....? and then push them in
And still are my pins long or short!?
I can get the king pins reamed "off car" into the hubs, but does that address the problem...unless I take the front axle off!
The bushes in the rear spring will certainly not be deformed as I throw them into the eye!, so I can do them off car. It was suggested that I coat them with solder to increase the o/d.....? and then push them in
And still are my pins long or short!?