02-06-2025, 02:18 PM
Hi All
The new axle tubes are now with me and included adjusters so I’m good to go (and I have). Thanks for everyone’s offers.
Question….I’ve drilled and tapped the axle ends for 5/16” bolts but when comparing them to the front Semi Girling stubs there is only about 3/16” of flange thickness whereas the fronts have at least 1/2”.
IMG_1414.jpeg (Size: 151.55 KB / Downloads: 88)
I would put nuts on the back but there are stiffening ribs in the way of two holes.
IMG_1415.jpeg (Size: 155.69 KB / Downloads: 89)
Do you think the flange thickness is sufficient?
Cheers
Howard
The new axle tubes are now with me and included adjusters so I’m good to go (and I have). Thanks for everyone’s offers.
Question….I’ve drilled and tapped the axle ends for 5/16” bolts but when comparing them to the front Semi Girling stubs there is only about 3/16” of flange thickness whereas the fronts have at least 1/2”.
IMG_1414.jpeg (Size: 151.55 KB / Downloads: 88)
I would put nuts on the back but there are stiffening ribs in the way of two holes.
IMG_1415.jpeg (Size: 155.69 KB / Downloads: 89)
Do you think the flange thickness is sufficient?
Cheers
Howard