5 hours ago
Thanks for advice.
I have a new spindle on order and had planned to make some bushes to fit the carb body , Allignment being the key issue I may have to buy a 7mm reamer.
It's the butterfly plate itself i would like to replace but both the spare carbs i have , have suffered with the same errosion on the plate at the point the spindle enters the body.
As i can't find any new ones i will have to result to silver solder and a fine file to achieve the best fit.
I have a new spindle on order and had planned to make some bushes to fit the carb body , Allignment being the key issue I may have to buy a 7mm reamer.
It's the butterfly plate itself i would like to replace but both the spare carbs i have , have suffered with the same errosion on the plate at the point the spindle enters the body.
As i can't find any new ones i will have to result to silver solder and a fine file to achieve the best fit.