The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.30 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wiper arm dimentions
#1
Will anyone tell me how to make the small flat metal piece of the wiper arm, I would love some pictures and measured dimensions. The piece I am looking for is on the right side on the 1st page.

http://www.da7c.co.uk/History%20Section/...%2030G.pdf
Reply
#2
(10-01-2022, 05:58 AM)Vancevr Wrote: Will anyone tell me how to make the small flat metal piece of the wiper arm, I would love some pictures and measured dimensions. The piece I am looking for is on the right side on the 1st page.

http://www.da7c.co.uk/History%20Section/...%2030G.pdf

You could scale the drawing so the shaft is 3/16 inch, print it out and then use it as a pattern for piercing from 18 swg steel sheet.

You'll need a piercing saw and fine blades.  https://www.hswalsh.com/product/eclipse-...ixed-ts125
Reply
#3
Thank you so much, I will give that a try
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)