+- Austinsevenfriends (https://www.austinsevenfriends.co.uk/forum)
+-- Forum: Austin Seven Friends Forum (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=1)
+--- Forum: Forum chat... (https://www.austinsevenfriends.co.uk/forum/forumdisplay.php?fid=14)
+--- Thread: DFL Dynamo and the NP1 Regulator (/showthread.php?tid=4441)
DFL Dynamo and the NP1 Regulator - Charles P - 31-05-2020
Back in times past I bought a modern type regulator from Mick Kirkland that was designed (I think) by Nick Plevan.
It's been on my shelf for decades and now I get round to using it can I find the instructions, can I hell.
Does anyone have, through a better filing system than I clearly have, the instructions for installing it and importantly adapting a mag engined DFL dynamo to 2 brush operation.
Thanks
Charles
RE: DFL Dynamo and the NP1 Regulator - Martin Baker - 31-05-2020
I've got a pdf of the instructions for the NP1 regulator, which is attached.
Good luck!
RE: DFL Dynamo and the NP1 Regulator - Charles P - 31-05-2020
Thanks Martin, but attached where?
I can't see them.
If you could email them to me at
charles@littlewrongs.org.uk
that would be very useful.
Thanks
Charles
RE: DFL Dynamo and the NP1 Regulator - Bob Culver - 01-06-2020
I dunno if the instructions refer particularly to the DFL dynamo but if it chances to retain the internal field resistor it might complicate matters.
RE: DFL Dynamo and the NP1 Regulator - Charles P - 01-06-2020
(01-06-2020, 10:45 PM)Bob Culver Wrote: I dunno if the instructions refer particularly to the DFL dynamo but if it chances to retain the internal field resistor it might complicate matters.
Bob
There is no internal field resistor in a DFL
C
RE: DFL Dynamo and the NP1 Regulator - Bob Culver - 02-06-2020
Sorry, the fact that the E comes after the F routinely trips me.