07-01-2018, 12:30 AM
Matt if you're happy with the fit so far, go ahead with the packing and bolt up the front half. If you're still happy then experiment with raising the rear half.
Bear in mind you will have then raised the body relative to the chassis along its entire length.
I'm not a fan of packing up the cow horns, some adjustment in starter hole fit can usually be achieved by slacking all the front panel bolts and pushing down on the rad cowl and/or raising the squashed rubber engine mounts.
Reduced packing at the front should reduce the requirement for packing all along the chassis particularly at the rear.
Thanks for the followup posting its always good to here results and good luck, cheers Russell
Bear in mind you will have then raised the body relative to the chassis along its entire length.
I'm not a fan of packing up the cow horns, some adjustment in starter hole fit can usually be achieved by slacking all the front panel bolts and pushing down on the rad cowl and/or raising the squashed rubber engine mounts.
Reduced packing at the front should reduce the requirement for packing all along the chassis particularly at the rear.
Thanks for the followup posting its always good to here results and good luck, cheers Russell