14-11-2019, 10:55 PM
Is the replacement head correct thickness, should be 1.5” a bit less if skimmed.
If excessively skimmed are the nuts bottoming out before clamping down on the head.
I can’t understand why you have reduced compression just by changing the head.
From what you described ie head changed it should run .
Was any levering involved in getting the old head off?
If it started and ran well before then it’s not going to be rings or valves.
If excessively skimmed are the nuts bottoming out before clamping down on the head.
I can’t understand why you have reduced compression just by changing the head.
From what you described ie head changed it should run .
Was any levering involved in getting the old head off?
If it started and ran well before then it’s not going to be rings or valves.