| The following warnings occurred: | ||||||||||||
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.28 (Linux)
|
|
Idling too fast
|
17-06-2019, 10:05 PM
(This post was last modified: 17-06-2019, 10:05 PM by Ian Williams.)
Did you centre the disk in the spindle when you rebuilt the carb, if not the disk will be hitting the side of the body preventing full closure. Release the screws to allow the disk to move slightly, hold the spindle fully shut to centre the disk in the body, re tighten the screws and all should be well again.
Black Art Enthusiast
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Idling too fast - by morrisminor - 14-06-2019, 04:59 PM
RE: Idling too fast - by David Stepney - 14-06-2019, 09:44 PM
RE: Idling too fast - by Bob Culver - 15-06-2019, 04:51 AM
RE: Idling too fast - by John Mason - 15-06-2019, 08:35 AM
RE: Idling too fast - by David Stepney - 15-06-2019, 07:54 PM
RE: Idling too fast - by morrisminor - 16-06-2019, 09:42 PM
RE: Idling too fast - by David Stepney - 16-06-2019, 11:06 PM
RE: Idling too fast - by Robert Leigh - 17-06-2019, 10:39 AM
RE: Idling too fast - by Ian Williams - 17-06-2019, 10:05 PM
|
