22-06-2019, 09:40 PM
My solution was to make a plate that took the place of one shackle, the pin is turned up from 7/16" steel and threaded into the plate in the same was as you would when refurbishing a shackle, the Joddle allows the plate to fit over the radius arm end and be installed behind the axle so as to retain a std appearance from the front. I machined up a thin wedge to go between the spring and chassis nose casting, and in this case as the radius arm ends are fabricated copies of Nippy/Ulster items I simply altered these slightly to retain the ball in the correct location.
Black Art Enthusiast