12-03-2019, 07:23 PM
David,
As RR says 10amps is a bit high adjust 3rd brush to 7or8amps.High power aluminum clad resistors can be found on ebay a value of 4R7 should be about right these are rated at 50watt.These can be bolted onto the bulk head to reduce the heat of the resistor,this is better than trying to wind your own resistor. Hope this helps.
As RR says 10amps is a bit high adjust 3rd brush to 7or8amps.High power aluminum clad resistors can be found on ebay a value of 4R7 should be about right these are rated at 50watt.These can be bolted onto the bulk head to reduce the heat of the resistor,this is better than trying to wind your own resistor. Hope this helps.