16-01-2019, 06:16 PM
(This post was last modified: 16-01-2019, 06:18 PM by Biddlecombe.)
(16-01-2019, 05:50 PM)Chris KC Wrote: I would put blocks of wood (or similar) under the face to take the blow rather than standing it on the studs. If the bearing is being replaced no need to worry about hitting it.
Maybe it's just the photo Peter but did that have any gasket / sealant between the two hub halves when it came apart?
Yes Chris, I havn't cleaned it up yet ready for the new one.
(16-01-2019, 05:48 PM)Steve Jones Wrote: Short lengths of tube of an assortment of diameters are useful for all sorts of things when working on Sevens.
Steve
![[Image: smile.png]](http://www.austinsevenfriends.co.uk/forum/images/icons/smile.png){kind=icon}
![[Image: thumbsup.png]](http://www.austinsevenfriends.co.uk/forum/images/icons/thumbsup.png){kind=icon}
Have some of them, thanks for the tip.