10-03-2019, 06:12 PM
FC66DD4D-41DB-4AA3-9F91-5144FEC2F24F.jpeg (Size: 144.34 KB / Downloads: 159)
Dear Tom
Thanks for the pictures of your very tidy rear end!
If I was starting from scratch I’d follow your front routing
through the hoop, but thought I’d have a go with the pipe
That came with one chassis.
What exactly does a fishtail do? Does it quieten the exhaust?
I know Tom A has one on one of his Cups and they were
obligatory at Brooklands.
My pipe diameter is 35mm OD so not standard at all.
I’m still messing about with pedal clearances, but will have to
remake the drivers side toe board to suit the new pedal positions.
Keen to sort out all underbonnet and front wiring in
Anticipation of the newly plated rad shell coming in a week or two.
The bonnet is completely finished and lacquered and ready to fit.
The CAV headlamp stalks will need some wedged washers
to get the lamps to point forward instead of cross eyed!
I may have to rethink the exhaust pipe routing as Neil pointed out that
I may not be able to make enough clearance between the pipe and
flitch plate at the point the pipe goes under the hoop....
Will keep you posted.
Hope you too can get to Guildtown.
Kind regards
Bill G
Based near the Scottish Border,