10-02-2019, 09:12 PM
(This post was last modified: 25-05-2019, 11:19 AM by AllAlloyCup.)
Hi Simon
I have a brass cast lever on the butterfly spindle
and I’ve bent the end of throttle cross shaft so that
it’s roughly under the end of the brass lever.
There’s not a huge amount of travel on the throttle pedal
and I just need to make sure that flooring the pedal approximates
to maximum opening of the butterfly, so probably will need to
Sit the engine in the chassis, fit the floor boards and bulkhead and then
Cut a suitable short throttle control rods with nice movement at each end with
No stiffness and effective return spring( already bought)
Will post pics when I’ve figured it out!!
Pls post photos if yours is set up.
Regards
Bill G
I have a brass cast lever on the butterfly spindle
and I’ve bent the end of throttle cross shaft so that
it’s roughly under the end of the brass lever.
There’s not a huge amount of travel on the throttle pedal
and I just need to make sure that flooring the pedal approximates
to maximum opening of the butterfly, so probably will need to
Sit the engine in the chassis, fit the floor boards and bulkhead and then
Cut a suitable short throttle control rods with nice movement at each end with
No stiffness and effective return spring( already bought)
Will post pics when I’ve figured it out!!
Pls post photos if yours is set up.
Regards
Bill G
Based near the Scottish Border,