05-02-2019, 01:20 PM
(This post was last modified: 05-02-2019, 01:23 PM by AllAlloyCup.)
Hi Hedd
By the cowl, do you mean the fabric cover that original GE Cups used?
I am planning to do machine turning on the bulkhead which is an
extra bit of bling I’ve been contemplating as well as replacing the fabric cowl
With an easily shaped alloy part to replace it?
I have a shrinker stretcher and quite a lot of alloy sheet left over so I can probably
manage most of it myself. Would need to see how easy it would be to remove
In case I needed to do work under it though.
Will make a cardboard one, like the dozens of patterns I’ve made since the start!!!
Regards
Bill G
Perhaps by cowl you meant the rad shell?
No it will be nickelled as it’s a steel chummy one.
At some stage I may paint the car... but not this year
Regards
Bill G
By the cowl, do you mean the fabric cover that original GE Cups used?
I am planning to do machine turning on the bulkhead which is an
extra bit of bling I’ve been contemplating as well as replacing the fabric cowl
With an easily shaped alloy part to replace it?
I have a shrinker stretcher and quite a lot of alloy sheet left over so I can probably
manage most of it myself. Would need to see how easy it would be to remove
In case I needed to do work under it though.
Will make a cardboard one, like the dozens of patterns I’ve made since the start!!!
Regards
Bill G
Perhaps by cowl you meant the rad shell?
No it will be nickelled as it’s a steel chummy one.
At some stage I may paint the car... but not this year
Regards
Bill G
Based near the Scottish Border,