Cup in a Box - resurrected from the old Forum...

[Ruairidh Dunford]

It’s all looking very trim - That’s a top notch trimmer who’s helped
with this phase of the build.

He is absolutely superb, I am utterly delighted with his work. The finish on this part is perhaps the most important and will make or break a build like this in my opinion.

I’m still researching materials for the hood. Originally it would have been a heavy twill ?
or was double duck invented then?

No idea Bill, sorry - I am after longevity on this and chose appropriately based on my other cars.

Have you opted for an Everflex material for the tonneau, hood bag, sidescreens and hood?

No, this is exterior quality vinyl leathercloth - for the reasons above.

I managed to get some stainless lift a dots from the USA as I’ve found with other types that they go rusty.

I’m interested to know if you’ve used double height lift a dot pegs on the rear cockpit?

I have had no problems like you describe with Lift The Dot fixings, all my cars are fitted with them.

The pegs are indeed double height.

I was going to use single ones as I was thinking, either the hood is on, or the tonneau is on, or the hood bag is on.

This is why I asked him to use them.

I’ll be interested to see the sidescreens too as I haven’t figured mine out yet though I’ve got some
frames made now.

I don't want to fit these, no need and it is very doubtful that I could drive safely with one on the driver's side for sure (I've tried).

This car is going to feature in magazines for years to come!!

Not in my ownership - I cannot think of anything worse. My enjoyment comes from, researching, building and then driving such vehicles, not much beyond that.