17-04-2018, 06:33 PM
No ign light = no spark. The bulb just shows that the dynamo is not charging, so if the engine is not turning, and the bulb is out then you have a problem.
Check that the contacts in the distributer are clean and open and close when you crank the handle. If OK, then on the coil, one wire goes to the contact breaker, and the other to the ignition switch. Disconnect that wire and connect a wire (ign switch wire) and temporarily run a wire from the battery to the coil. If that works, then its time to investigate ign switch and wiring between coil and switch.
Check that the contacts in the distributer are clean and open and close when you crank the handle. If OK, then on the coil, one wire goes to the contact breaker, and the other to the ignition switch. Disconnect that wire and connect a wire (ign switch wire) and temporarily run a wire from the battery to the coil. If that works, then its time to investigate ign switch and wiring between coil and switch.