04-01-2018, 08:56 PM
(This post was last modified: 04-01-2018, 09:03 PM by Ruairidh Dunford.)
Three bearing crank removal.
1. Remove the centre main oil pipe feed union.
2. Get rear into the position below (rear will be hard up against where the union above ‘was’).
3. Rotate crank clockwise from rear and bring the front up as below.
4. Continue to rotate, bring up and out...
5. Remove...
1. Remove the centre main oil pipe feed union.
2. Get rear into the position below (rear will be hard up against where the union above ‘was’).
3. Rotate crank clockwise from rear and bring the front up as below.
4. Continue to rotate, bring up and out...
5. Remove...