29-11-2019, 02:51 PM
I fit these by putting a small bolt upwards through the cap, tube and cup but not protruding above the tube at the top. The bolt needs to be smaller than the 1/4 BSF that fits, but as big as possible to pass through.
While holding the 1/4 BSF bolt in position in the hole in the cap I then hit the end of the cap smartly with a hammer. This causes the spring to compress enough for the bolt to pass into the tube and cup. The small bolt drops out and the boltcan be tapped right through.
While holding the 1/4 BSF bolt in position in the hole in the cap I then hit the end of the cap smartly with a hammer. This causes the spring to compress enough for the bolt to pass into the tube and cup. The small bolt drops out and the boltcan be tapped right through.
Jim