30-09-2019, 09:55 PM
Come to fit the suggested 9v bulb.
Side of bulb not making contact
Is it best to bend the bulb holder ?
I have two original lights both the same
Don’t want to damage the holders
Regards
Tim
Side of bulb not making contact
Is it best to bend the bulb holder ?
I have two original lights both the same
Don’t want to damage the holders
Regards
Tim
(03-08-2019, 08:19 AM)Dave Wortley Wrote: Hello Tony,
Hope the chummy is going well except for the heat problem. If you search “boiling petrol” on here you can see the mods I have done to sort it out. The next alteration was to turn the loop to horizontal instead of vertical as was suggested. Also the rubber wedge mod under the rear of the bonnet.
Regards to Anne. Mike is doing his usual top quality job as mag editor.
Cheers,
Dave.